I have a RB4011 I am setting up. The configuration was imported from a older router due to the VPN configurations I want to bring over along with all the previous configurations.
I have the LAN configured as a bridge which is setup to use ethernet ports 2 through SFP+.
WAN should be ethernet 1. However with that said for some reason I am getting a LAN address on port 1 even though it is not configured to be a part of the bridge and frankly I'm not sure where the problem is at.
I have the LAN configured as a bridge which is setup to use ethernet ports 2 through SFP+.
WAN should be ethernet 1. However with that said for some reason I am getting a LAN address on port 1 even though it is not configured to be a part of the bridge and frankly I'm not sure where the problem is at.
Statistics: Posted by PTechS — Wed Jan 17, 2024 5:00 am