As a total beginner, I need to configurate a network with Mikrotik wsAP ac lite. Everything is working perfectly, but the initial “handshake” takes too long (up to 5 seconds).
I have 20 clients that occasionally send GET requests to a web server (these clients are connected for sending procedure only!). The very first request takes several second until the device appears in “list of active devices”. However, each next request (regardless of the device) is almost instant. Problem arises after approximately 10 second of idleness when the device disappears from the list (as it was mentioned the client is connected less than 1 second) causing the next request to take too long again.. When some other device is connected to network permanently (e.g. my laptop), everything runs swiftly all the time.
The question is simple: how can I configure this AP to maintain the ability of “instant” sending?
Thank you for any guidance or assistance
Apologies for any inaccuracies in the terminology.
I have 20 clients that occasionally send GET requests to a web server (these clients are connected for sending procedure only!). The very first request takes several second until the device appears in “list of active devices”. However, each next request (regardless of the device) is almost instant. Problem arises after approximately 10 second of idleness when the device disappears from the list (as it was mentioned the client is connected less than 1 second) causing the next request to take too long again.. When some other device is connected to network permanently (e.g. my laptop), everything runs swiftly all the time.
The question is simple: how can I configure this AP to maintain the ability of “instant” sending?
Thank you for any guidance or assistance
Apologies for any inaccuracies in the terminology.
Statistics: Posted by mmUser — Thu Jan 25, 2024 11:01 am